Step 1.
Using a small screwdriver or needlenosen pliers push the small sear pin to the right.
(looking from the front of the frame)
Step 2.
Using a punch push out the sear pin leaving the punch in the frame. If you leave the
punch inserted in the frame none of the rear frame components will go flying out.
Step 3.
Slowly pull your punch out and remove
(looking frome the front and the punch pushed in from the left and exiting to the right)
the ejector, sear spring, sear and finring pin safety lever.
Step 4.
Take a 3/32 punch and knock out the grip safety pin leaving the punch in. Slowly
slide the puch out keeping your fingers on both the rear (outside the frame) and on top
(inside the frame) of the grip safety to keep the spring from flying out and slowy
release the tension.
Now pull the spring and grip safety out of the frame. And the frame is now disassembled
here is how the spring goes back in the frame for reassembly.
Click below to continue next steps in slide disassembly
